Inspection and measurement equipment
Polarity detector
Polarity detector
This is a polarity detector that checks the polarity of magnets.
The case is made without using any resin, but from recycled cardboard.
The product will be delivered in a set containing one cardboard box and a radial ring magnet.
Please note that customers will be required to assemble the product.
*Anyone can easily make this without using scissors or glue.
How to assemble
|
Part Number |
①Main housing ②Magnetic holder ③ Shaft holder -1- ④ Shaft holder -2- ⑤Axis ⑥Ring magnet ⑦NS judged magnet |
Assemble ①.
*Assemble the side with the mold by folding it in half.
 |
 |
Make a crease on ② as shown in the picture.
*Please assemble by folding along the dotted lines.
 |
Combine parts ① and ② together so that the holes line up.
 |
 |
Make sure it is fully inserted and the holes are aligned.
 |
 |
Turn it over and prepare shaft holders ③ and ④.
 |
⑤ Fold the shaft in half, align the shaft holder with the hole in the main housing, and gently insert it.
 |
Look through the peephole and insert it this far.
 |
While holding the shaft, drop the magnet into the peephole.
 |
Insert the magnet into the shaft.
(It's a little difficult to thread, so if you have a magnet nearby, you can adjust its position to make it easier.)
 |
Finally, insert the remaining shaft holder and it's complete.
 |
Slightly crushing the tip of the shaft will make it harder to remove.
 |
Have fun determining the magnetic poles!
 |